Secure Easy Ordering 203-333-1412 www.beckson.com HAND PUMPS MODEL# LENGTH WIDTH HEIGHT STROKES/GAL CAPACITY 954DP2 9″ (23 cm) 6-1/4″ (16 cm) 4-1/2″ (11.4 cm) 28 oz PER STROKE (.8 L) 16 GPM (60 L) • Corrosion-proof marine plastic. • More than double the capacity of competitively priced pumps. • 2-position stainless steel handle and adjustable (octagonal) frame permit up to 16 variations in stroke direction. • Mounts vertically on bulkhead or horizontally on deck; no need for special brackets. • Uses Beckson FH-1-1/2 (3.8 cm) or VCS-1-1/2 (3.8 cm) hose. Order separately. (Dimensions with handle removed) DIAPHRAGM PUMP 954DP2 ALL PLASTIC • SELF PRIMING • SELF LUBRICATING • EASY CLEANING WILL NOT CORRODE • NON-SPARKING • VISIT WWW.THIRSTY-MATE.COM SIPHON PUMPS SPECIALTY TRANSFER PUMPS Safety experts caution against the unsafe practice of siphoning petroleum by mouth, warning especially that it can result in a loss of life. Beckson's answer was to invent the Siphon-Mate® pump; a combination displacement lift pump with valves suitable for transferring fuel. MODEL# 109PC SIPHON PUMP FOR: DIESEL - OIL - WATER LENGTH: 11-1/2″ (29.2 cm) DIAMETER: 1-1/4″ (3.2 cm) LIFTS: 4 oz (.12 L) OPEN SIPHON FLOW RATE: 1 gal/min. Supplied with 8' of clear tubing to allow versatile application. Cut tubing for desired length of intake and discharge hoses. This pump is not intended for transfer of liquid over 120° F (49° C) nor for solvents that will attack PVC. • Acts as a positive displacement hand lift pump. • Siphons downhill if liquid level in source is higher than receptacle. • Non-metallic, will not spark or mar finishes. • Non-corrosive, non-rusting. MODEL# 109A SIPHON PUMP FOR: KEROSENE - DIESEL LENGTH: 9″ (22.9 cm) DIAMETER: 1-1/4″ (3.2 cm) LIFTS: 4 oz. per stroke (.12 L) per stroke OPEN SIPHON FLOW RATE: 1 gal/min. Supplied with 6′ clear tubing solvent welded to intake and 3′ clear tubing solvent welded to the outlet. Tubing may be cut to desired length. The right angle foot was designed for using the pump in tight spaces. This pump is not intended for transfer of liquid over 120° F (49° C) nor for solvents that will attack PVC. 109A NEW! SIPHON PUMPS: EASY OPERATION! Begin pumping to start flow. Once flow begins, fully extending the handle will allow siphoning, provided that the source is higher in elevation than the receptacle. Siphon action stops when handle is depressed AND hose is removed from the source. WARNING! Plan carefully for liquid to drain from pump and hose after dispensing. This is especially important with flammable liquids. Remove pump from container when not in use to prevent unintentional siphon action or unauthorized use. 109 PC * 8 PUMPS 109PC AND 109A: SEE SAFETY INFORMATION on page 54. Also, read and follow the information on the Safety and Instruction Sheet included with your pump. ! SIPHON PUMPS NOT FOR TRANSFER OF HOT OIL! SEE SAFETY INFORMATION, PAGE 54 ! WARNING! Cancer and Reproductive Harm - www.P65Warnings.ca.gov MODEL# 109A, MODEL# 109PC !